Quote:
Originally Posted by ***First of Two Latin Kings***
Picture????
|
Thats because thats an printed off screen shot of splinter so of course spinter's gonna be there.
For those who has loose torso here's an easy fix...
Quote:
He was pretty loose and slouched quite a bit. I ended up soaking him in boiling water and he popped apart pretty easily. I tried a few things to stiffen the joint but ended up wrapping a rubber o-ring around the shaft of the barbell joint. It provided enough friction to keep Raph from slouching and help him hold poses.
A little more detail on the Raphael torso joint fix: I popped his head off and soaked him belly down for a minute in a pan of boiled water. The torso joint popped apart quite easily. The joint is a simple barbell/socket arrangement. After a couple of failed attempts to tighten things up, I ended up using a large black rubber o-ring that I wrapped around the barbell shaft 3 times. I reheated the socket for snapping the barbell back in by spooning some boiling water into it and waiting about 20 seconds. At that point I dumped the water out and snapped it back together. Raph is now as tight as his turtle brother, Donnie! Los Tortuga Hermanos!
No, the torso just pops straight out of the top of the shell. I boiled the water in an electric kettle and then poured it into a plastic Rubbermaid pan that was large enough to accommodate Raph's carcass. I removed the head prior to this as it helped him fit into the pan and also prevented the fabric mask ends from getting wet. I never actually boil the figure itself. I always have the water removed from the heat source prior to immersion.
|